Tips For Installing Baseboard Trim

Installing trim is one of the most difficult parts of renovating a room. Installing a baseboard trim is something like icing on a cake and must be considered as a fun project that indicates the end of what might have been a long, difficult job. In addition to window and wall trim, it is the finishing touch, the highlight, the piece of resistance – and realizing this will help drive you conveniently toward its perfection. However don’t do such a hurry which you don’t be careful to get it done right!

Finger-Joint or Continuous-Grain

Before buying, decide no matter if you will be staining or painting after the installation of baseboard trim. It will be of importance in the price of the trim. For baseboard which is likely to be painted, you may purchase the less-expensive finger-joint trim, and that is molding made by machining and joining shorter pieces together to create one continual length of trim. The seams are noticeable, but rather effectively covered with paint. If you plan to stain the trim, however, you should choose continuous-grained baseboard. This higher-priced baseboard trims costs higher but brings about an appealing continuity highlighted by the smooth grain of the wood produced by stain. Do all staining or painting of the molding before unit installation.

Start installation of baseboard trim at an outside corner, in case one is present in your room. Or else, start at the wall on the opposite part of in which the door entering into the room is situated. As it is the first wall everyone sees once they enter a room, you really want this to have the best-looking baseboard possible. When you run short for whatever reason on the other walls and must splice pieces, it is so visible.

Angled and Square Ends

You can use a power miter saw for installing baseboard at the corners. You can visit to explore more about Milter Saw Reviews . A T-bevel can gauge unusual angles that do not measure what must be neat and when walls are not square to floors, the trim can be coped to go well with a coping saw.

For the first part of baseboard trim, the cut is very simple: It’s best to make both ends square, and no need angle cutting. It really is the subsequent, attaching baseboard which should be fitted at both corner of this item. Both pieces are also angled only at those corners with their opposite’s ends becoming square. The remaining baseboards are cut with angled ends getting together with square ends until the room is done.


Leave a reply